Now switch back to Ext4 and swipe to confirm. Click on the option "Select a file to flash". Put the phone in fastboot Mode, Power Button and Volume Down key. Don't forget to reboot after flashing and voila, the new TWRP is installed. For TWRP go to this website, click on "Get TWRP for your device" and type you device's name to download the image for it: Download TWRP here. Click on the option "Download TWRP-x.x.x-x-xxxxxx.img".
I've succeeded to boot directly into TWRP with ADB, select the TWRP.img to be install as recovery, select boot to recovery and… I'm stuck at the same place: the fairphone logo.
TWRP (AKA Team Win Recovery Project) is an open-source software custom recovery image for Android-based devices. Your phone must be connected to your computer via USB. This way, if your Fairphone 2 is damaged or lost, you can go back to the.
Continue holding the reset button for 10-15 seconds. In case you've got previously installed versions of TWRP, download and extract TWRP_Hydrogen_3.0.2.2_All. Step Five: Boot Into TWRP Recovery Unplug your phone and use the volume down key to scroll to the "Recovery" option in your bootloader. Press download, turn off the phone and connect to the PC. this step is important so that once you flash TWRP, your device doesn't replace the custom recovery (TWRP) with the system recovery. boot -system image -vendor image which one do i pick edit: the instructions for the rom state 03. Step 8: Then, click on Flash to Recovery. Step 2: Download and extract Qualcomm Flash Image Loader (QFIL) on your computer. I found that trying to do the restore of the backed up system partition whilst still in twrp 3.3.1-0 resulted in a boot loop when I booted up the restored ROM and I got similar results with using twrp. Press the volume up or power button (depending on your phone) to select it. Move the folder to your phone storage and flash the image using already installed TWRP recovery. A4 Select Partition to Flash Image: Boot Recovery. Let's say your /data partition maps to /dev/mmcblk0p28. The flash should complete in just a few seconds. It will navigate you to the downloaded image file. Wait until installation process is finished. Tap the 'Install Image' button on the bottom-right to switch TWRP to image installation mode.